Toshiba B-FP3D SERIES Maintenance Manual

© 2016-2019 Toshibatec Corporation All right reserved B-FP3D Series Maintenance Manual
Revision Record
Version: 0002
Page Contents
2-2 Step 6) Cover open button  Open button
2-4 Step 11) For the GH model, procedure for removing the adhesive tape from the
thermal head assembly has been added.
2-5 to 2-8 Step numbers have been corrected.
2-6 Step 15) For the GH model, procedure for removing the IP54 sheet from the Battery
frame has been added.
2-7 Step 16) For the GH model, procedure for attaching the sheet to the battery frame
with after replacing the CPU PC board has been added.
For the GH model, procedure for attaching new adhesive tape to the thermal head
assembly has been added.
2-10 Step 1) For the GH model, procedure for removing the Thermal head for has been
added.
Step 2) For the GH model, procedure for removing the IP54 water resisting
materials has been added.
Step 3) For the GH model, procedure for attaching the IP54 water resisting
materials to the new LCD unit has been added.
2-12 Step 2) For the GH model, procedure for replacing the exclusive battery unit and
attaching new tape to the thermal head assembly has been added.
2-13 Step 4) For the GH model, procedure for attaching new adhesive tape to the
thermal head assembly has been added.
Step number 4) was missing
2-16 Step 5) For the GH model, procedure for removing the adhesive tape from the
thermal head assembly has been added.
Step 6) For the GH model, procedure for attaching new adhesive tape to the
thermal head assembly has been added.
2-18 Step 3) Remove the Upper sensor on from the Print Head cover.
2-19 Step 5) Explanation of how to remove the black cover has been partly changed.
Step 6) NOTE: picture below  picture above
Step 7) For the GH model, procedure for attaching new adhesive tape to the
thermal head assembly has been added.
2-21 Step 3) Paper Guide Outlet  Paper Guide Assembl
y
2-22 Step 4) Explanation on how to remove the platen roller has been changed.
2-23 Step 3) Explanation on how to remove the peel-off unit has been changed.
2-24 Step 4) Push  Pull
2-25 Step 7) For the GH model, procedure for attaching new adhesive tape to the
thermal head assembly has been added.
2-26 Step 3) Explanation on how to remove the peel-off PCB has been changed.
Step 4) Step number has been corrected.
For the GH model, procedure for attaching new adhesive tape to the thermal head
assembly has been added.
2-27 Step 2) Add of 2 screws
Step 3) Roller Clip  Roller Clips

Toshiba B-FP3D SERIES Specifications

General

Brand	Toshiba
Model	B-FP3D SERIES
Category	Printer
Language	English