Toshiba BMS-CT1280E - Check the Output Status of the Air Conditioner(S) (Power Level); Check the Indoor Temperature Detected by the Outdoor Unit (Outdoor Temp.); Erase FILTER Sign (Filter Sign Reset); Set Middle COOL (Soft Cooling)

Touch Screen Controller Owner's Manual
42
-EN
Check the output status of the air conditioner(s) (Power Level)
You can check how much power the air conditioner is using for operation.
● NOTE
Displayed in the case of a compatible air conditioner.
Check the indoor temperature detected by the outdoor unit (Outdoor temp.)
You can check the temperature inside the room detected by the outdoor
unit.
● NOTE
Displayed in the case of a compatible air conditioner.
* Depending on conditions such as the location of the indoor unit
installation, it may differ from the actual indoor temperature.
Erase FILTER Sign (Filter sign reset)
When a device has operated for a certain period of time, a warning
(FILTER Sign) is displayed to indicate that the filter should be cleaned.
After filter cleaning, tap [(1)].
● NOTE
Displayed in the case of a compatible air conditioner.
If you set the air conditioners where a sign is displayed to [OK], the
cumulative time for the sign display is set to 0.
Set Middle COOL (Soft Cooling)
Middle COOL can be turned ON/OFF. When turned ON, the air direction is
set to up, and the maximum power is restricted.
● NOTE
• Displayed when a configurable model is connected.
• The settings screen is displayed when the air conditioner is in operation
and the operation mode is COOL.
(1)(1)