e-STUDIO160/200/250 SCANNER 7 - 2 December 2002 TOSHIBA TEC
7.2 Configuration
The following describes the configuration of the optical system and the purpose of its components.
(1) Original glass
The original glass is for placing the original. The original is illuminated by light from the exposure lamp
passing through the original glass.
(2) Carriage 1
Carriage 1 is driven by the scanning motor to scan the original, and is made up of the following parts:
a. Exposure lamp
The exposure lamp emits the light for illuminating the original. (Xenon lamp)
b. Reflector
The reflector is for efficiently directing light from the exposure lamp onto the surface of the original.
c. Mirror 1
Mirror 1 is for guiding light reflected from the original to mirror 2. Mirror 2 is described later on.
Original
Original glass
Exposure lamp
Mirror 1
Reflector
08-02-02
Carriage 1
08-02-01
Exposure lamp
Mirror 1
Reflector
To Next Page
Loading...
