December 2002 TOSHIBA TEC 4 - 5 e-STUDIO160/200/250 COPIER OPERATION
4.3 Fault Detection
Errors are roughly classified into the following three kinds:
4.3.1 Classification of faults
A) Warning error An abnormal condition which can occur even during normal op-
eration, such as a paper empty state. After stoppage, the opera-
tion can be resumed. It can occur even during non-operation.
Display • Add paper
• Toner is low
• Drum life warning
B) Jam error An error where the copier can be restored when the operator re-
moves the cause of the abnormal condition from the machine.
Display • Toner empty
• Check process
• Misfeed in copier
• Misfeed in doc. feeder
• Misfeed in duplexer
• Misfeed in finisher
• Misfeed in bypass
C) Error subject to service call An error which has detected that the machine cannot be operated.
In this case, turn the power OFF.
Display • Call for service
To Next Page
Loading...
