Toshiba e-studio 250 - Copying Using Cassette 1

e-STUDIO160/200/250 COPIER OPERATION 4 - 12 December 2002 TOSHIBA TEC
Start button ON
Transfer system control
YES
Process system control Optical system control
End of optical
system control
Main motor ON
Polygon motor ON
Process unit fan motor high speed rotation
Development bias ON
Separation bias ON
Charge bias ON
Discharge lamp ON
Main motor
OK?
Pickup clutch ON
Retraction of carriage
Black shading
Exposure lamp ON
Stop of carriage
Advance of carriage
White shading
Scanning of document
Stop of carriage
Exposure lamp OFF
Retraction of carriage
Stop of carriage
End of process
system control
Polygon motor OFF
Laser ON
Transfer bias ON
Transfer guide bias ON
Laser OFF
Transfer bias OFF
Transfer guide bias OFF
NG
Paper jam
"E01"
NO
Service call
"C01"
YES
Polygon motor
OK?
NO
Service call
"CA1"
YES
Remaining
copy count 0?
OK
Exit sensor
check 1
NG
Paper jam
"E02"
OK
Exit sensor
check 2
NO
NO
Service call
"CA2"
YES
HSYNC
OK
YES
Remaining
copy count 0?
Pickup clutch OFF
Ragistration roller
clutch ON
Ragistration roller
clutch OFF
NO
Charge bias OFF
Main motor OFF
Development bias OFF
Separation bias OFF
Discharge lamp OFF
Process unit fan motor low speed rotation
Standby
4.4.3 Copying using cassette 1