December 2002 TOSHIBA TEC 4 - 1 e-STUDIO160/200/250 COPIER OPERATION
4. COPIER OPERATION
4.1 Operation Outline
Copier Operation Operation during warm up and standby
Automatic feed copying using START key
Copying Operation Bypass-feed copying
Interrupt Copying
4.2 Description of Operation
4.2.1 Warming up
(1) Initialization
• Turn on the power switch.
• The message “Please wait” appears on the display.
• The PS fan motor operates and the process unit fan motor operates at low speed.
• Initialization of optical unit
The carriage moves to the home position and then stops.
The peak position is detected as the carriage moves.
The Exposure lamp lights and the peak is detected (Shading sheet is detected).
The Exposure lamp goes off.
• Initialization of paper feed mechanism
Each tray is lifted. (It will not move if it has already been lifted.)
(2) When the temperature of the heat roller has been sufficiently stabilized, the copy quantity shows “1”
and the word “READY” appears.
To Next Page
Loading...
