Toshiba e-studio 250 - Page 41

e-STUDIO160/200/250 OUTLINE OF THE MACHINE 2 - 28 December 2002 TOSHIBA TEC
Screw
Screw
Main cover
Screw
022
[U] Main cover
1. If a Finisher (MJ-1011) is attached to the copier,
detach the finisher plate and junction block.
2. If a JSP (MJ-5001) or OCT (MJ-5002) is
attached to the copier, detach it.
3. If an Original Cover (KA-1600PC), ADF
(MR-2012), or the RADF (MR-3011) is attached
to the copier, open it.
4. Detach the toner cartridge.
5. Detach scanner cover. (See Fig. 2-6-3)
6. Detach control panel front cover. (See Fig. 2-6-6)
7. Detach control panel bottom cover. (See Fig. 2-6-7)
8. Detach ozone cover. (See Fig. 2-6-9)
9. Detach paper tray cover. (See Fig. 2-6-10)
10. Detach front frame covers F and R. (See Fig. 2-6-18 and 2-6-19)
11. Detach front cover. (See Fig. 2-6-22)
12. Remove 4 screws, release 2 hooks, and detach main cover.
[T] Front cover
1. Open front cover, release one hook, and detach
front cover.
Fig. 2-6-22
Hook
Front cover
021
Fig. 2-6-23
[V] Ozone filter 2
1. Detach ozone filter 2 from the rear cover.
Ozone filter 2
Rear cover
029
Fig. 2-6-24