Toshiba E-STUDIO600 - Page 212

e-STUDIO520/600/720/850 ADJUSTMENT March 2005 © TOSHIBA TEC
3 - 12
For tandem LCF
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON. ! (Adjustment Mode)
(2) Press [1] ([3] for duplexing) ! [FAX]. (A grid pattern with 10 mm squares is printed out.)
(3) Check the grid pattern on the test chart printed out and measure the distance D from the leading
edge of the paper to the 6th line of the grid pattern.
* Normally, the 1st line of the grid pattern is not printed.
* At the duplexing, measure it on the top side of the grid pattern.
(4) Check if the distance D is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance D again.
(Adjustment Mode) ! (Key in the code shown above) ! [START]
! (Key in an acceptable value shown above)
! [ENTER] or [INTERRUPT] (Stored in memory)
! “100% A” is displayed
! Press [1] ([3] for duplexing)! [FAX] ! (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance D becomes (approx. 0.4 mm/step).
Order for
adjustment
Paper source Code Paper size
Acceptable
value
Remarks
1 1st drawer 440 A4 0 to 40
2 2nd drawer 441 A3 0 to 40
3 Tandem LCF 429 A4 0 to 40
4 LCF 443 A4 0 to 40
5 Bypass feed 442 A3 0 to 40
6 Duplexing 445 A3 0 to 40 Paper fed from the 2nd/4th drawer
- All 408 - 0 to 80