March 2005 © TOSHIBA TEC e-STUDIO520/600/720/850 ADJUSTMENT
3 - 13
3
[E] Primary scanning data laser writing start position at duplexing
Note: Note:
Make sure the first line of the grid pattern is printed out since the line is occasionally vanished.
[E-1] Adjustment for long-sized paper
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON. ! (Adjustment Mode)
(2) Press [3] ! [FAX]. (A grid pattern with 10 mm squares is printed out. Use A3/LD in the 2nd/4th
drawer.
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
(Adjustment Mode) ! (Key in code [498]) ! [START] ! [0] ! [START]
! (Key in a value (acceptable values: 0 to 255))
! [ENTER] or [INTERRUPT] (Stored in memory)
! “100% A” is displayed.
! Press [3] ! [FAX]#!#(A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes (0.05 mm/step).
[E-2] Adjustment for short-sized paper
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON. ! (Adjustment Mode)
(2) Press [3] ! [FAX]. (A grid pattern with 10 mm squares is printed out. Use A4/LT in the 1st
drawer/tandem LCF.
(3) Check the grid pattern on the test print and measure the distance E from the left edge of the
paper to the 6th line of the grid pattern.
(4) Check if the distance E is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance E again.
(Adjustment Mode) ! (Key in the code [498]) ! [START] ! [1] ! [START]
! (Key in a value (acceptable values: 0 to 255))
! [ENTER] or [INTERRUPT] (Stored in memory).
! “100% A” is displayed
! Press [3] ! [FAX] ! (A grid pattern is printed out.)
* The larger the adjustment value is, the longer the distance E becomes (0.05 mm/step).
<Adjustment procedure summarization for A to E>
[0] [5] [Power ON] ! [1] ([3](05-445, 498) for duplex) ! [FAX]
A: 05-401 (2nd/4th drawer, A3/LD)
! 200±0.5 mm
(e-STUDIO 520/600/720: 0.3 mm/step,
e-STUDIO 850: 0.1 mm/step)
B: 05-411 (2nd/4th drawer, A3/LD)
! 52±0.5 mm (0.05 mm/step)
To Next Page
Loading...
