38 Changing Scan Settings
0.Changing Scan Settings
“Scan settings” are settings applied commonly when scanning to any location with this equipment.
To change the settings for a particular job, press [Scan Setting] from the Scan menu or each scan screen and set each
option.
Scan setting screens are divided into different pages. If you finish changing the desired settings, press [OK] to set your
selections and continue the scan operation.
The following pages describe how to change the settings according to each purpose. Which setting is changed varies
depending on which option you change. In the following pages, the factory default settings are underlined.
P.39 “Specifying the color mode”
P.39 “Specifying the resolution”
P.40 “Selecting the original mode”
P.40 “Changing the orientation”
P.41 “Scanning 2-Sided originals”
P.41 “Specifying the original size”
P.42 “Changing the compression ratio”
P.42 “Removing blank pages”
P.43 “Erasing black frames around images”
P.44 “Adjusting the exposure”
P.44 “Adjusting the contrast”
P.44 “Adjusting the background density”
P.45 “Adjusting the sharpness”
P.45 “Adjusting the color balance”
P.46 “Reducing the ADF scan noise”
P.46 “Settings for reading out original characters (OCR)”
The settings described in this section are not applied to the WS scan function.
When performing a WS scan, install the WIA driver to your client computer and configure the driver settings.
If you do not change the settings for a particular job, the scan settings registered by default settings are applied.
P.16 “Default Settings”
To Next Page
Loading...
Need help?
General
