3.USEFUL FUNCTIONS
Scanning With Dual Functions (Dual Agents) 55
USEFUL FUNCTIONS
4
On the Scan menu, press [Scan].
To clear the scan functions, select one and press [Reset]. The screen on the touch panel returns to the basic scan
menu and the selected button is cleared.
When the equipment has scanned more than 1000 pages in a job, the “The number of originals exceeds the
limit. Do you want to save stored originals?” message appears. If you want to save the scans, press [Yes].
When the temporary workspace is full on the equipment’s hard disk, a message appears and the job is
canceled. The available workspace can be viewed on the TopAccess [Device] tab.
If the number of jobs waiting to store scans in the equipment’s hard disk exceeds 20, a message appears to
indicate that the equipment’s memory is full. In this case, wait a while until memory becomes available again
or delete unnecessary jobs from [Job Status].
To learn more about viewing job statuses, refer to the Software Troubleshooting Guide.
To Next Page
Loading...
Need help?
General
