40 H7 ASD Operation Manual
Protection Parameters Cumulative Run Timer Cumulative Run Timer Alarm Setting F621
Phase Loss Output Phase Loss Detection Enable/Disable F605
Low Current Settings Low Current Trip/Alarm Configuration F610
Abnormal Speed Settings
Abnormal Speed Detection Filter Time F622
Overspeed Detection Frequency Range F623
Speed Drop Detection Frequency Range F624
Short Circuit Detect Pulse
Short-Circuit-Pulse Run Command F613
Short-Circuit-Pulse Run Duration F614
Overtorque Settings
Overtorque Trip Enable/Disable F615
Overtorque Trip/Alarm Level During Power
Operation
F616
Overtorque Trip/Alarm Level During
Regeneration
F617
Overtorque Detection Time F618
Brake Fault Timer
Braking Trouble Internal Timer F630
Release After Run Timer F632
Base Frequency Voltage
Supply Voltage Compensation Enable/Disable
F307
Output Voltage Limitation Enable/Disable
Soft Start
Suppression of Inrush-Current Timing
F609
Interlock with ST
Torque Setting Parameters
Set Points
VI/II F205
RR F214
RX F220
RX2 F226
BIN F232
Torque Control
Torque Command Selection F420
Torque Command Filter F421
Synchronized Torque Bias Input Selection F422
Tension Torque Bias Input Selection F423
Load Sharing Gain Input Selection F424
Torque Limit Settings
Positive Torque Limit #1Selection F440
Negative Torque Limit #1 Selection F442
Manual Settings F441
Torque Limit Mode F450
Torque Limit Mode (speed dependent) F451
Program Menu Navigation
Primary Menu Sub Menu Parameter Name
Parameter
Number
www . ElectricalPartManuals . com
To Next Page
Loading...
