Toshiba HX7+ ASD - Keypad Remote Mounting; Remote Keypad Required Hardware

HX7+ ASD Installation and Operation Manual 41
Keypad Remote Mounting
The HX7+ ASD may be controlled from a remotely-mounted keypad. For safety and application-specific
reasons, some ASD installations will warrant that the operator not be in the vicinity during operation or
that the keypad not be attached to the ASD housing. The keypad may be mounted either with or without
the optional HX7+ ASD Remote Mounting Kit (P/N ASD-MTG-KIT). The ease of installation is
enhanced by the HX7+ ASD Remote Mounting Kit which allows for easier cable routing and keypad
placement.
The keypad can operate up to distances of 15 feet from the ASD via the Common Serial (TTL) Port. For
distances beyond 15 feet, the RS232/RS485 port is recommended.
Remote mounting will also allow for multiple keypad mountings at one location if controlling and
monitoring several ASDs from a central location is required.
The optional dust cover (P/N ASD-BPC) may be used to cover the front panel opening of the ASD
housing after removing the keypad. A keypad extender cable is required for remote mounting. keypad
extender cables are available in lengths of 7, 10, or 15 feet and may be ordered through the Toshiba
Customer Support Center.
Remote Keypad Required Hardware
Keypad Mounting Hardware
• 6-32 x 5/16” Pan Head Screw — P/N 50595 (4 ea.)
• #6 Split-Lock Washer — P/N 01884 (4 ea.)
• #6 Flat Washer — P/N 01885 (4 ea.)
Bezel Plate Mounting Hardware
• Bezel Plate — P/N 52291
• 10-32 Hex Nut — P/N 01922 (4 ea.)
• #10 Split-Lock Washer — P/N 01923 (4 ea.)
• #10 Flat Washer — P/N 01924 (4 ea.)
• Dust Cover — P/N ASD-BPC (Optional)
Extender Cables
• ASD-CAB7F: Cable, RJ45, 7 ft.
• ASD-CAB10F: Cable, RJ45, 10 ft.
• ASD-CAB15F: Cable, RJ45, 15 ft.