HX7+ ASD Installation and Operation Manual 59
Program Screen Menu Navigation
Table 13 lists the menu items of the Program mode and maps the flow of the menu selections. The
Parameter Numbers for the listed functions are provided where applicable. The functions listed may be
accessed (and changed) as mapped below or via the Direct Access method: Program Direct Access
applicable parameter number.
Table 13. Program Mode Menu Items.
Program Menu Navigation
Primary Menu Sub Menu Parameter Name
Parameter
Number
F
UNDAMENTALS
Frequency Setting
Maximum Frequency F011
Upper Limit F012
Lower Limit F013
V/f Pattern F015
Standard Mode Selection
Command Mode F003
Frequency Mode #1 F004
Frequency Mode #2 F207
Reference Priority Selection F200
Mode #1/#2 Switching Frequency F208
Accel/Decel #1 Settings
Accel #1 F009
Decel #1 F010
Accel/Decel Pattern F502
Automatic Accel/Decel (check box) F000
Motor Set #1
#1 Base Frequency F014
#1 Max Output Voltage F306
#1 Torque Boost F016
#1 Electronic Thermal Protection Level F600
S
TARTUP
W
IZARD
(See the section titled Startup Wizard Requirements on pg. 53.) N/A
C
HANGED
F
ROM
D
EFAULT
(See the section titled Default Setting Changes on pg. 45.) N/A
D
IRECT
A
CCESS
(See the section titled Direct Access Parameter Information on pg. 72.) N/A
EOI O
PTION
S
ETUPS
(keypad)
Contrast (adjustment)
Darker (highlight Darker and press Enter) N/A
Lighter (highlight Lighter and press Enter) N/A
Local|Remote Key
Command (check box) N/A
Frequency (check box) N/A
Realtime Clock Setup
Date and time setting (requires RTC option) N/A
Preferences
Double Click Speed N/A
Arrow Speed N/A
Encoder Speed N/A
Encoder Action N/A
Alarm Popups
(check box)
Over-Heat Alarm N/A
Undervoltage Alarm N/A
To Next Page
Loading...
