Toshiba HX7+ ASD - Monitor Screen

56 HX7+ ASD Installation and Operation Manual
Monitor Screen
The Monitor mode allows the user to monitor HX7+ ASD/motor performance variables, ASD control
settings, and configuration data during motor operation. The monitored parameters are listed and
described below.
Note: The Monitor mode is a read-only mode. The settings cannot be changed from the
Monitor mode. For information on how to change the values, see the section titled
Default Setting Changes on pg. 45.
Running Frequency — Displays the Output Frequency.
Frequency Reference — Displays the Frequency Setpoint.
Output Current — Displays the Output Current of the ASD as a percentage of the rated capacity
of the HX7+.
Bus Voltage — Displays the Bus Voltage as a percentage of the rated capacity of the HX7+.
Output Voltage — Displays the Output Voltage as a percentage of the rated capacity of the HX7+.
Discrete Input Terminal Status — Displays the status of the discrete input terminals of the
Control Terminal Strip.
Out1 Out2 FL — Displays the status of the discrete output terminals of the Control Terminal Strip.
Timer — Displays the Cumulative Run Time in hours.
Postcomp Frequency — Displays the Output Frequency after the application of the slip
compensation correction value.
Feedback (inst.) — Provides a status of the Real Time Feedback in Hz.
Feedback (1 second) — Provides a status of the 1-Second Averaging feedback in Hz.
Torque — Displays the Output Torque as a percentage of the rated capacity of the HX7+.
Torque Reference — Displays the Torque Reference as a percentage.
Torque Current — Displays the current being used to produce torque.
Excitation Current — Displays the current required to produce the excitation field.
PID Value — Displays the PID feedback value in Hz (Proportional-Integral-Derivative).
Motor Overload — Displays the Motor Overload value as a percentage of the rated capacity of the
motor.
ASD Overload — Displays the ASD Overload as a percentage of the rated capacity of the HX7+.
DBR Overload — Displays the DBR Overload value as a percentage of the Dynamic Braking
Resistor capacity.
Motor Load — Displays the Motor Load in real time as a percentage of the rated capacity of the
motor.
ASD Load — Displays the ASD Load as a percentage of the rated capacity of the HX7+.
DBR Load — Displays the DBR Load as a percentage of the Dynamic Braking Resistor capacity.
Monitor
Screen
Monitor