Toshiba IK-TU51CU - Page 21

(d) C hanging the automatic shutter zone area
0 Set the " to AREA by pushing [MENU UP], [MENU DOWN] buttons.
(D Set the measurement light area by pushing [DATA UP], [DATA DOWN] buttons.
PRESET A PRESET B PRESET C PRESET D
PRESET E USER
(e) Confirming the contents of the measurement light area selected by the automatic shutter
0 Set the to AREA DISP by pushing [MENU UP], [MENU DOWN] buttons.
® Area screen appears by pushing [DATA UP], [DATA DOWN] buttons.
When AREA is set to USER, the setting can be changed on the area menu. When changing the area, refer
to the item “7.2 (8) Setting USER area”.
® Push the [DISP] button to return to the menu.
(f) Changing the CCD storage mode
0 Set the to FLD/FRM by pushing [MENU UP], [MENU DOWN] buttons.
(D Select either FLD (field) or FRM (frame) by pushing [DATA UP], [DATA DOWN] buttons.
(g) Changing the freeze operation setting
0 Set the ” to FREEZE INPUT by pushing [MENU UP], [MENU DOWN] buttons.
(D Set the freeze operation by pushing [DATA UP], [DATA DOWN] buttons.
When set to FRONT :The Freeze Operation is performed by using the FREEZE button on the front
panel.
When set to TRIG jf L : The Freeze Operation is performed at the rising edge of the rear TRIG input.
When set to TRIG %T" : The Freeze Operation is performed at the falling edge of the rear TRIG input.
21