Toshiba IK-TU51CU - Default Chapter; Table of Contents

TABLE OF CONTENTS
1. CAUTIONS ON USE AND INSTALLATION. 6
2. COMPONENTS. 6
3. ITEMS CONTROLLED BY USING ON SCREEN DISPLAY. 7
4. NAMES AND FUNCTIONS. 8
5. CONNECTION.10
5.1 Standard Connection. 10
5.2 Cautions on Connection. 10
5.3 Connection on Back Panel. 10
5.3A Connector Pin Assignments. 11
6. OPERATION.12
6.1 Automatic Black Balance. 12
6.2 White Balance. 13
6.3 Scene File. 15
6.4 Gain. 15
6.5 Shading Correction. 16
6.6 Freeze Operation. 17
7. MODE SETTING BY ON SCREEN DISPLAY.17
7.1 Using the Menus. 17
7.2 Menus. 19
(1) SHUTTER (Electronic shutter). 19
(1.1) Changing each setting in AUTO mode. 20
(1.2) Changing each setting in MANUAL mode.22
(1.3) Changing each setting in SS(synchro. scan) mode.23
(1.4) Changing each setting in EXT TRIG mode.24
(1.4.1) Changing each setting in 1 PULSE SNR mode.24
(1.4.2) Changing each setting in 1 PULSE SR mode. 25
(1.4.3) Changing each setting in 2 PULSE mode.26
(1.4.4) Changing each setting in RS232C mode.27
(2) GAIN (Video gain).27
(2.1) Changing the maximum gain in AUTO (Automatic gain control) mode.28
(2.2) Changing gain in MANUAL mode.28
(3) WHT BAL (White balance). 29
(3.1) Changing the AWB (Automatic White Balance)mode setting.29
(3.2) Changing the ATW (Automatic Trace White Balance)mode setting.30
(3.3) Changing the MANUAL mode setting.31
(4) PROCESS (Process). 32
(4.1) Changing the gamma correction ON/OFF.32
(4.2) Changing gamma correction level.32
(4.3) Changing black gamma correction level.33
(4.4) Changing two-dimension low pass filter.33
(4.5) Changing detail (outline) gain.33
(4.6) Changing detail boost frequency.33
(4.7) Changing master pedestal.34
(4.8) Changing chroma gain.34
(4.9) Changing DNR(Digital Noise Reduction).34
(5) MATRIX(Matrix color correction).35
(5.1) Changing MATRIX color correction ON/OFF.35
(5.2) Changing each of MATRIX setting.35
(6) SYNC. 36
(6.1) INT screen.36
(6.2) Changing EXT setting.36
4