Toshiba IK-TU51CU - (4.7) Changing Master Pedestal.34; (4.8) Changing Chroma Gain.34; (4.9) Changing DNR(Digital Noise Reduction).34

(4. 7) Changing master pedestal
(D Set the ” to M. PED by pushing [MENU UP], [MENU DOWN] buttons.
® Set the master pedestal by pushing [DATA UP], [DATA DOWN] buttons.
[DATA UP]- ► M PED rises
—5CH- ► 0 < - ► 50
M PED decreases < -[DATA DOWN]
* When DTL OUT ON is selected in OPTION menu, the display M. PED turns off automatically.
So the M. PED change cannot be performed.
-- 4 PROCESS
<FILE A>
— GAMMA ON/OFF
OFF
DTL B. FRQ
NORMAL
CHROMA GAIN
0
DNR
OFF
-- 4 PROCESS
<FILE A>
—GAMMA ON/OFF
ON
GAMMA
0
BLACK GAMMA
NORMAL
DTL B. FRQ
NORMAL
CHROMA GAIN
0
DNR
OFF
Menu when DTL OUT ON is selected in OPTION menu.
(4. 8) Changing CHROMA GAIN
<J> Set the ” to CHROMA GAIN by pushing [MENU UP], [MENU DOWN] buttons.
® Set the chroma gain by pushing [DATA UP], [DATA DOWN] buttons.
[DATA UP]- ► Chroma gain increases.
—128*- ► 0 ◄ - ► 127
Chroma gain increases. < -[DATA DOWN]
Note:
The chroma gain setting is only valid for VBS output signals and Y/C output signals. It is not valid for
the RGB output in the RGB terminal, the Y/Pr/Pb outputs or the DIGITAL terminal’s digital output
signals.
(4. 9) Changing DNR (Digital Noise Reduction)
(D Set the to DNR by pushing [MENU UP], [MENU DOWN] buttons.
® Select either ON or OFF by pushing [DATA UP], [DATA DOWN] buttons.
Note:
When DNR is set to ON, noise is reduced, but the resolution decreases slightly.
34