Toshiba IK-TU51CU - 1 Cautions on Use and Installation; 2 Components

1. CAUTIONS ON USE AND INSTALLATION
•Carefully handle the units.
Do not drop, or give a strong shock or vibration
to the camera. This may cause problems.
Treat the camera cables carefully to prevent
cable problems, such as cable breakdown and
loosened connections.
•Do not shoot intense light.
If there is an intense light at a location on the
screen such as a spot light, a blooming and
smearing may occur.
When intense light enters, vertical stripes may
appear on the screen. This is not a malfunction.
Ghosts may occur when there is an intense light
near the object. In this case, change the
shooting angle.
•Install the camera in a location free
from noise.
If the camera or the cables are located near
power utility lines or a TV, etc. undesirable
noise may appear on the screen. In such a
case, try to change the location of the camera
or the cable wiring.
•Moire
When thin stripe patterns are shooted, stripe
patterns that are not actually there (moire) may
appears as interference stripes. This is not a
malfunction.
•Operating ambient temperature and humidity.
Do not use the camera in places where temperature
and humidity exceed the specifications. Picture
quality will lower and internal parts may be
damaged.
Be particularly careful when using in places
exposed to direct sunlight. When shooting in hot
places, depending on the conditions of the object
and the camera (for example when the gain is
increased), noise in the form of vertical strips or
white dots may occur. This is not a malfunction.
•Handling of the camera head and
protection cap.
Keep the camera head and the protection cap away
from children. Children may put them into mouth or
swallow them accidentally. The protection cap
protects the image sensing plane when the lens is
removed from the camera head, do not throw away.
•When not using the camera for a longtime.
Turn off the camera power switch and stop
supplying power.
•When cleaning the camera
Always turn off the power and make a cleaning with
a piece of dry cloth. If necessary, gently wipe with a
cloth dampened with thinned detergent. Do not use
benzine, alcohol, thinner, etc. If used, coating and
printed letters may be discolored. When cleaning
the lens, use a lens cleaning paper, etc.
2. COMPONENTS
(1) Camera Control Unit.1
(2) Accessories
(a) Instruction manual.1
6