Toshiba IK-TU51CU - (7.1) Chaging OUTPUT1 Output; (7.2) Chaging OUTPUT2 Output; (7.3) Chaging Shading Correction Mode.37; (7.5) Chaging RGB SYNC.37

(7) OPTION
• OUTPUT1 RGB, Y/PR/PB
• OUTPUT2 VBS, Y/C
• SHADING MODE SET, MANUAL, OFF
• Manual shading setting -128 to 127
• RGB SYNC G, ALL ON, ALL OFF
• Freeze display ON, OFF
• Nega/Posi inversion SW NEGA, POSI
• Detail signal output ON, OFF
• RS232C baud rate 9600bps, 19200bps
(7. 1) Changing OUTPUT1 output
® Set the ” to OUTPUT1 by pushing [MENU UP], [MENU DOWN] buttons.
(D Select either RGB or Y/PR/PB by pushing [DATA UP], [DATA DOWN] buttons.
(7. 2) Changing OUTPUT2 output
0 Set the ” to OUTPUT2 by pushing [MENU UP], [MENU DOWN] buttons.
(D Select either VBS or Y/C by pushing [DATA UP], [DATA DOWN] buttons.
(7. 3) Changing shading correction mode
® Set the ” to SHADING by pushing [MENU UP], [MENU DOWN] buttons.
(D Select SET, MANUAL or OFF by pushing [DATA UP], [DATA DOWN] buttons.
(7. 4) Changing manual shading correction mode
(D Set the ” to MANUAL by pushing [MENU UP], [MENU DOWN] buttons.
(D Set manual shading correction by pushing [DATA UP], [DATA DOWN] buttons.
[DATA UP] - ►
-127^- ► 0 - ► 128
◄ -[DATA DOWN]
* When the shading correction mode is set to anything other than MANUAL, the display turns off, so
the setting cannot be made.
(7. 5) Changing RGB SYNC
® Set the to RGB SYNC by pushing [MENU UP], [MENU DOWN] buttons.
(D Select G, ALL ON or ALL OFF by pushing [DATA UP], [DATA DOWN] buttons.
* When Y/PR/PB is selected at OUTPUT1, the display RGB SYNC turns off automatically. So RGB
SYNC change cannot be performed.
37