Toshiba IK-TU51CU - (1.3) Changing each Setting in SS(Synchro. Scan) Mode.23

(1. 3) Changing each setting in SS(synchro. scan)mode
Shutter mode AUTO, MANUAL, SS, EXT TRIG
Synchro, scan setting
1/525H—260/525H—OFF— FLD : 1FRM-—255FRM
FRM : 2FRM*— ► 256FRM
FLD/FRM SW FLD, FRM
Freeze operation selection FRONT, TRIG-^L , TRIG "V
< MODE = SS >
(a) Changing the shutter speed setting
CD Set the to SYNCHRO SCAN by pushing [MENU UP], [MENU DOWN] buttons.
(D Select the shutter speed by pushing [DATA UP], [DATA DOWN] buttons.
[DATA UP] - ►
1/525H ◄ - ► 260/525H OFF+-MFRM*- ► 255FRM at FLD
2FRM _ 256FRM^ at FRM
◄ -[DATA DOWN] Long time exposure
(b) Changing the CCD storage mode
® Set the to FLD/FRM by pushing [MENU UP], [MENU DOWN] buttons.
® Select either FLD (field) or FRM (frame) by pushing [DATA UP], [DATA DOWN] buttons.
(c) Changing the freeze operation setting
® Set the ” to FREEZE INPUT by pushing [MENU UP], [MENU DOWN] buttons.
(2) Set the freeze operation by pushing [DATA UP], [DATA DOWN] buttons.
When set to FRONT : The Freeze Operation is performed by using the FREEZE button on the front
panel.
When set to TRIG jf]_ : The Freeze Operation is performed at the rising edge of the rear TRIG input.
When set to TRIG tT : The Freeze Operation is performed at the falling edge of the rear TRIG input.
Note:
The longer the storage time with extended exposures, the more visible certain characteristics of CCD
cameras become: fixed pattern noise, white pixels, etc.
23