Toshiba IK-TU51CU - (1.4.3) Changing each Setting in 2 PULSE Mode.26

(1. 4. 3) Changing each setting in 2PULSE mode
Shutter mode AUTO, MANUAL, SS, EXT TRIG
EXT TRIG mode
1 PULSE SNR, 1 PULSE SR, 2PULSE, RS232C
Input trigger pulse setting at 2PULSE
J1_TL ••• The rising edge
U lt — The falling edge
j L — Front and back edges of pulse
FLD/FRM SW FLD, FRM
< MODE = EXT TRIG EXT TRIG = 2PULSE>
(a) Changing inputting trigger pulse setting
0 Set the " to TRIG PULSE by pushing [MENU UP], [MENU DOWN] buttons.
(D Select either J1_ TL , u - LT orJ L by pushing [DATA UP], [DATA DOWN] buttons.
* This setting is only valid in the 2PULSE mode. To make the trigger pulse setting when using the
1 PULSE mode, first set the EXT TRIG mode to 1 PULSE SNR or 1 PULSE SR, then make the settings
with the TRIG PULSE items.
(b) Changing the CCD storage mode
0 Set the ” to FLD/FRM by pushing [MENU UP], [MENU DOWN] buttons.
® Select either FLD (field) or FRM (frame) by pushing [DATA UP], [DATA DOWN] buttons.
Note:
The longer the storage time with extended exposures, the more visible certain characteristics of CCD
cameras become: fixed pattern noise, white pixels, etc.
26