IPedge
The Basics
20 TOSHIBA
IPedge UG 01/13
LCD Contrast Available on backlit telephones and backlit add-on module.
To adjust the LCD contrast on the backlit telephones
1. Press and hold down the Mic button
2. Press and release Vol
s or Vol t repeatedly
Note: Holding the Vol button does not continue to change the setting. The
button must be pressed for each step of contrast change
To adjust the LCD contrast on the Add-on Module
1. Press 3+6+9+Hold (simultaneously)
2. Press
Contrast + button to increase contrast
3. Press
Contrast - button to decrease contrast
4. Lift the handset off-hook / on-hook to save settings
Note: Holding the soft key does not continue to change the setting. The soft
key must be pressed for each step of contrast change
Brightness Control Available on backlit telephones with 4-line LCD’s and backlit add-on module.
To change the LCD back light brightness
1. Press 3+6+9+Hold (simultaneously)
2. Press
Bright soft key to increase brightness
3. Press
Dim soft key to decrease brightness
4. Lift the handset off-hook / on-hook to save the settings
Note: Use the
BL BRIGHT and BL DIM buttons in steps 2 and 3 on the 10
button LCD Add-on Module
To change the LCD backlight brightness for IP5131-SDL or
IP5631-SDL
1. Press 3+6+9+Hold (simultaneously)
2. Press the
Others soft key
3. Press the
BL Bright soft key
4. Enter a value of 0~3 using the keypad. (0 = dim; 3 = brightest)
5. Press the
Set soft key twice
To Next Page
Loading...
