IPedge
Feature Operations
IPedge UG 01/13 TOSHIBA 39
Advisory Messages can only be set using the IP5000-series telephone. The
preset advisory messages can be displayed using the Enterprise Manager
Personal Administration (EMPA).
Set Advisory Message 1. Go off-hook or press your extension button to hear the dial tone.
2. Press #411
3. Enter Message number (see table above)
4. Enter additional digits if required.
5. Go on-hook or press Spkr to release the line.
Clear Registered
Message
1. Go off-hook or press your extension button to hear the dial tone.
2. Press #412.
3. Go on-hook or press Spkr to release the line.
Display Preset
Advisory Messages
1. Login to the EMPA.
2. Select System Info then the Advisory Message tab.
Alarm Notification The Alarm Notification Button must be set up by your System Administrator on
your station.
When the Alarm Notification button displays
• Call your System Administrator.
This button stops displaying when the alarm clears or when you press the flashing
button. If the alarm has not been cleared the Alarm Notification Button flashes
every 10 minutes.
4
RETURN ON________ Date (e.g., 10 20)
5
6
7
8
9
Advisory Message Default Code Table
Msg No. Characters Displayed Additional Digits
To Next Page
Loading...
