Toshiba IP5000-Series - LED Indicator Details

IPedge
The Basics
28 TOSHIBA
IPedge UG 01/13
LED Indicator Details Each line and Programmable Feature Button has a LED next to it which
indicates the status of the line or feature associated with the button. Line
LEDs light red or green and flash at varying rates to indicate call status (see
table below).
Table 5 LED Indicators
Feature LED
Interval Rates
Your Station (Green) Other Station (Red)
Extension In-Use access outside line
2 seconds On, 1/8 second Off
— 1/8 second On/Off
steady
Incoming Call while ringing
1 second on at 10 pulses/sec-
ond —1 second Off
one second On/Off
Hold – outside line
if using Pooled Line Grp, the hold
indication is only at the station
that places the call on hold.
4 pulses/second for 1/8 second
On/Off
1/2 second On/Off
Hold – Consultation
during consultation/transfer to
another station
10 pulses/second steady
Hold – Exclusive outside line
10 pulses/second steady
Hold – Recall
when held call recalls your idle
station
1 second at 2 pulses/second,
1 second at 10 pulses/second
flashes
Hold – Exclusive
Recall
Exclusive Recall
1 second at 2 pulses/second,
1 second at 10 pulses/second
steady
Internal Call while station ringing
Your extension button flashes
10 pulses/second—1 second
Off
[SDN] red flashing or
green ringing
Busy Station
Transfer
outside call transferred to your
busy station from a designated
station or:
4 pulses/second, 1/8 second
On/Off
3/4 second on, 1/8
second Off
After disconnecting first call
10 pulses/second 2 pulses/second
Conference Conference call
10 pulses/second steady