55
Learning the Basics
Using the wireless mouse
Replacing the batteries
Batteries are required to power the wireless mouse. The battery
light glows red when the battery power is low.
To replace the batteries:
1 Save your work and turn the mouse upside down.
(Sample Illustration) Mouse underside
2 Slide the mouse ON/OFF switch on the underside to the OFF
position.
3 Slide the Battery cover off.
4 Always replace both batteries at the same time with fresh ones.
5 Replace the battery cover.
6 Slide the mouse ON/OFF switch to the ON position.
If a battery is leaking or its case is cracked, put on protective gloves
to handle it, and discard it immediately. Always dispose of used
battery packs in compliance with all applicable laws and regulations.
Put insulating tape, such as cellophane tape, on the electrode during
transportation to avoid a possible short circuit, fire or electric shock.
Failure to do so could possibly result in serious injury.
Battery cover
Mouse ON/OFF switch Connect button
To Next Page
Loading...
Need help?
General