Toshiba nv Series - Page 28

Chapter 2 Name and Function of Module Components
6F8C1872
12
•
Mode 2 setup switch (binary DIP switch)
Used to set the action when there is a controller error or transmission error.
Set to "OFF" at shipment.
Table 2-4 Mode 2 setup switch
Mode
MD4
MD5
Data update
Abnormal
Transmit data
Receive data
Halt1
OFF
OFF
Halt
CE
---
---
TE
---
Value just before error
Halt2
OFF
ON
halt
CE
---
---
TE
---
0
Resume1
ON
OFF
Resume
CE
Value just before
error
Data received from master
TE
---
Value just before error
Resume2
ON
ON
Resume
CE
0
Data received from master
TE
---
0
CE: Controller Error TE: Transmission Error
•
Address setup switch (decimal rotary switch)
Use to set the slave's node address (1 to 99). Set to "1" at shipment.
NAx10 : 10’s digit (module lower side)
NAx1 : 1’s digit (module upper side)
Cutout side
Cutout side
Cutout side
NAx1
NAx10
The above figure is set to node address "00". (Actual setting should be between 1 and 99.)
Align the notch side of the knob with the desired value.
Figure 2-5 Node address setting