4.4 The Status of LED when the Controller is Started
Unified Controller nv series type2 light Controller Unit Instruction Manual
5
Table 1-2 Mode select switch setting
DSW No.
Function Description DIP switch
DSW-1 Reserved by the
manufacturer.
Turn off all switches.
DSW-2
DSW-3
DSW-4
DSW-5
DSW-6
DSW-7 ON Memory clear
Memory is cleared the next
time the power is turned on.
DSW-8 ON
・
Set all switches to ‘OFF’ when out of manufacture and normal using.
◆
Important
・
When “memory clear” is specified, programs and control data are initialized the next time
the power is turned on.
Table 1-3 IP address switch setting
Switch name Setting Switch
STN-H
Sets higher-order digits (0 - F) of LSD
of IP address in hex.
STN-L
Sets lower-order digits (0 - F) of LSD
of IP address in hex.
・
The switch is set to ‘00’ when out of manufacture.
・
The switch cannot set to ‘00h’ or ‘FFh’.
STN-H
STN-L
DSW-2
DSW-1
DSW-3
DSW-4
DSW-5
DSW-6
DSW-7
DSW-8
OFF
ON
To Next Page
Loading...
