Toshiba nv Series - System Configuration

Chapter 1 On Installing type2 light Controllers
6F8C1575
10
1.5 System Configuration
This section describes the controller unit configuration of the unified controller nv
series type2 light, the system configuration with I/O connection and the system
configuration connected with nV-Tool.
■
Controller unit configuration
The controller unit allows controller single configuration and controller duplex
configuration.
(1)
Controller single configuration
Figure 1-4 Controller single configuration
Table 1-7 Application of parts of the controller single configuration

Name Model Application
Base unit BUM22 Single/duplex chassis extended slot x 1
Rear mounted,
Duplexed power support
Power module PS693 100 - 240VAC (85 - 264V)
power
5V-7A
Controller module PUM21 nv series type2 light controller
Serial bus interface module SBM21 SBIF adapter
 
ACK1

ACK2


SB-1

SB-2



ＳＢＭ２１

POWER

ＰＳ６９３


ＰＵＭ２１
RUN

HALT

PRUN

TRUN

HLTH

RUN

ONL

STBY

HALT

ERR

ALM

BATT

TRK

LP

SCAN

EN-B

LP
-
1

LP-2

EN-A

ACT
-1

ACT
-A

ACT
-2

ACT
-B

LNK
-1

LNK
-2

LNK
-A

LNK
-B


UseforPowermoduleslot Blankmodule(BPM2P)
Useforextendedslot Blankmodule(BPM21)
Useforcontrollermoduleslot Blankmodule(BPM22)

Useforextendedslot Blankmodule(BPM21)  Useforextendedslot Blankmodule(BPM21) 
Controller module
Serial bus interface module

Base unit
Power module