Toshiba nv Series - 4.1 Checking the Switch before Starting

Chapter 4 Starting and Stopping
6F8C1575
48
4.1 Checking the Switch before Starting
The controller module has the operation mode switch and nV-Tool Ethernet IP address
setting switch. Check if these switches are correctly set.
■ Operation mode key switch
Table 4 − 1 Operation mode key switch
Key position Description Key switch
HALT
・ The controller starts in HALT mode when the power is
turned on.
・ A HALT command is invoked when set from other key
position.
・ RUN mode cannot be selected from nV- Tool.
RUN
・ The controller starts in RUN mode when the power is
turned on.
・ A RUN command is invoked when set from other key
position.
・ HALT mode can be selected from nV- Tool.

PRUN
・ Same as the RUN position except that programs
cannot be changed from nV- Tool.




■ Mode setting switch
Table 4-2 Function of mode setting switch
DSW NO. Function Description Dip switch
DSW-1 Reserved by
manufacturer 
Always turn these switches
off. 
DSW-2
DSW-3
DSW-4
DSW-5
DSW-6
DSW-7 ON Memory clear
selection 
Memory is cleared when the
power is turned on next time
. 
DSW-8 ON

◆
Important
・
When “memory clear” is specified, programs and control data are initialized the
next time the power is turned on.
HALT
RUN

PRUN
HALT
RUN

PRUN
HALT
RUN

PRUN
DSW-2

DSW-1

DSW-3

DSW-4

DSW-5

DSW-6

DSW-7

DSW-8

OFF

ON