Toshiba nv Series - 3.1 Power Wiring

Chapter 3 Connecting Devices
6F8C1575
38
3.1 Power Wiring
Observe the precautions listed below for wiring the type2 light controller. For the wiring of
TC-net I/O, refer to “TC-net I/O Instruction Manual” (6F8C1240). For the wiring of the
intelligent I/O, refer to “Intelligent PI/O Instruction Manual (6F8C0779).
WARNING
Ground the equipment.
An electric shock and a fire may be caused.
WARNING
Turn off the power before wiring the cable.
Failure to observe it may cause an electric shock and a
trouble.
WARNING
Use a sheath crimping terminal or shield the wire of the
module.
Exposed conductive part may cause an electric shock.
CAUTION
Connect the external power that meets the rating.
Failure to observe it may cause an explosion and a fire.
CAUTION
A
worker with product knowledge should install wiring.
Wrong wiring may cause an electric shock, a fire and a
trouble.
◆
Important
・ Connect required wire and line.
Be sure to use a sheath crimping terminal to wire cables.
・ Check the wire and line are correctly and firmly connected and close the terminal
block cover of the module.
Note
・ Do not connect anything to the NC part.
Mandatory

Mandatory

Mandatory

Mandatory

Ground