4.8 Base assembly 4 Replacement Procedures
PORTÉGÉ R830/Satellite R830 Maintenance Manual (960-880) [CONFIDENTIAL] 4-27
Installing the Base assembly
To install the base assembly, follow the steps below and refer to Figure 4-11 to 4-14.
1. Set the base assembly to the cover assembly.
NOTE: Set the base assembly as shown in the figure below.
2. Secure the base assembly and cover assembly with the following screws and set the
dock cover (No-dock model only) to the base assembly.
Dock model
• M2.5×6B FLAT HEAD screw ×15 (Described as “6” in the Figure 4-12)
• M2.5×4B FLAT HEAD screw ×5 (Described as “4” in the Figure 4-12)
No-Dock model
• M2.5×6B FLAT HEAD screw ×13 (Described as “6” in the Figure 4-13)
• M2.5×4B FLAT HEAD screw ×5 (Described as “4” in the Figure 4-13)
• M2.5×12B FLAT HEAD screw ×2 (Described as “12” in the Figure 4-13)
To Next Page
Loading...
