4 Replacement Procedures 4.21 DC-IN harness
4-72 [CONFIDENTIAL] PORTÉGÉ R830/Satellite R830 Maintenance Manual (960-880)
4.21 DC-IN harness
Removing the DC-IN harness
To remove the DC-IN harness, follow the steps below and refer to Figure 4-44.
1. Take out the DC-IN harness from the slot of the cover assembly.
Figure 4-44 Removing the DC-IN harness
Installing the DC-IN harness
To install the DC-IN harness, follow the steps below and refer to Figure 4-44.
1. Set the DC-IN harness into the slot of the cover assembly.
NOTE: When replacing a DC-IN harness with a new one, stick a DC-IN insulator to the
DC-IN harness in place.
DC-IN harness
To Next Page
Loading...
