4.15 E-SATA board 4 Replacement Procedures
PORTÉGÉ R830/Satellite R830 Maintenance Manual (960-880) [CONFIDENTIAL] 4-49
Installing the E-SATA board
To install the E-SATA board, follow the steps below and refer to Figure 4-29.
1. Peel off the double-side tapes (D-tape circle) on the cover assembly.
2. Stick new double-sided tapes (D-tape circle) and peel off the separator.
3. Connect the E-SATA board FPC to the connector CN9640 on the back of the E-
SATA board.
4. Set the E-SATA board to the guides and secure it with the following screw.
• M2×4C S-THIN HEAD ×1
5. Fix the E-SATA board FPC with the double sided tapes.
To Next Page
Loading...
