4.26 Camera module 4 Replacement Procedures
PORTÉGÉ R830/Satellite R830 Maintenance Manual (960-880) [CONFIDENTIAL] 4-95
Installing the Camera module
To install the camera module, follow the steps below and refer to Figure 4-55.
1. Stick a new D-stick tape to the LCD cover and peel off the separator.
NOTE: When replacing the LCD mask with a new one, stick a D-stick tape to the LCD
cover in place.
When sticking the D STICK TAPE, refer to the following figure.
2. Connect the camera harness to the connector on a new camera module and stick the
camera module to the slot of the LCD cover.
3. Arrange the camera harness in place and fix it with the insulators.
To Next Page
Loading...
