4.30 Fluorescent Lamp 4 Replacement Procedures
2. Remove the screws (E) on both sides.
The maximum allowed releasing torque is
0.1078N
¥
m (1.1kgf
¥
cm).
Figure 4-151 Removing the screws from the sides
3. Flip the module over again (with the top of the module facing up) and remove the two
latches that are close to the lamp.
Latch
Figure 4-152 Removing the latches close to the lamp
Satellite A20 Maintenance Manual (960-444) 4-193
To Next Page
Loading...
