4 Replacement Procedures 4.30 Fluorescent Lamp
4. Using the U-shaped edge of the bezel as a "hinge," raise the edge of the bezel from
which the latches have been removed. Then remove the bezel. Peel off the tape for
GND wire fixing (J).
U-shaped edge
of the bezel
Tape for ground
wire fixing (J)
Figure 4-153 Removing the bezel
5. Flip the bezel over and remove the two screws (E) and lamp cover (F). Then replace
the lamp unit (G) with a new one.
Maximum allowed
releasing torque is
0.1078N
¥
m (1.1kgf
¥
cm).
Figure 4-154 Removing the lamp cover
4-194 Satellite A20 Maintenance Manual (960-444)
To Next Page
Loading...
