4.5 ODD Bay Module 4 Replacement Procedures
4.5 ODD Bay Module
Removing the ODD Bay Module
NOTE: The installation and removal procedures are the same for all the modules that
can be installed in the ODD bay. See the appropriate sections for the disassembly
procedures of specific modules.
Remove the ODD bay module according to the following procedures and Figures 4-7.
1. Turn the computer upside down.
2. Remove the M2x4 black flat head screw.
3. Push out on the ODD bay module in the direction of the arrow.
CAUTION: Handle the ODD bay module carefully it can become hot during operation.
ODD bay module
M2x4 black
flat head screw
Figure 4-7 Removing the ODD bay module
Satellite/Satellite Pro/A500/A505/A507/dynabook Maintenance Manual 4-19
To Next Page
Loading...
