2.6 SSD 2 Troubleshooting
Procedure 2 Connector Check and Replacement Check
The SSD or system board may be faulty. Disassemble the computer following the steps
described in Chapter 4 and perform the following checks:
Check 1 Make sure the following connectors have been firmly connected to the SSD,
system board and CPU.
Satellite/Satellite Pro/A500/A505/A507/dynabook Maintenance Manual 2-17
System board
CPU
SSD
If any connector is loose or off, reconnect it firmly and return to Procedure 1.
If there is still an error, perform Check 2.
Check 2 The SSD may be damaged. Replace it with a new one following the
disassembling instructions in Chapter 4. If the problem persists, perform
Check 3.
Check 3 The System board may be damaged. Replace it with a new one following
the disassembling instructions in Chapter 4. If the problem persists,
perform Check 4.
Check 4 The CPU may be damaged. Replace it with a new one following the
disassembling instructions in Chapter 4.
To Next Page
Loading...
