4 Replacement Procedures
3. Remove 1 piece of tape securing FL cable and disconnect the FL cable from connector
CN1, and HV cable from connector CN2, and then remove the FL inverter.
Figure 4-46 Removing the FL inverter
CN 1
CN 2
4. Remove the following screws securing the LCD unit on LCD back cover.
• M2.5×4L FLAT HEAD screw ×2
5. Remove the LCD unit from LCD back cover, and place the LCD back cover facedown
on a protective surface.
Figure 4-47 Removing the LCD Unit
4-74 Satellite/Satellite Pro U500/U500D, PORTEGE M900/M900D Maintenance Manual
To Next Page
Loading...
