Toshiba SMMS-e - Display of Indoor Unit Information; Display of Outdoor EEPROM Writing Check Code

46
Monitor Function
* The latest check code written in the EEPROM of each outdoor unit is displayed.
(This function is used to check the check code after the resetting of the power supply.)
To display the check code, push SW04 and hold for at least 5 seconds after setting SW01 to 03 as shown in the
table below.
• 7-Segment Display
Set SW01/SW02/SW03 to [1/1/16] and push SW04 and hold for at least 5 seconds. The latest che
ck code of the
header unit (U1) will be displayed.
If the setting of SW02 is changed, the latest check code of a follow unit (U2-U3) will be displayed.
Anoitcesyalpsidtnemges-7sserddaroodnI30WS20WS10WS
1 E. 1
***
***
***
.
Latest check code of header unit (U1)
Latest check code of follower unit No. 1 (U2)
Latest check code of follower unit No. 2 (U3)
1
2
16
E. 2.
3 E. 3.
Section A
Section B
D600 D601 D602 D603 D604
(5) Display of Indoor Unit information (Display on Header Unit only)
(6) Display of Outdoor EEPROM Writing Check Code (Display at each Outdoor Unit)
B
4
Indoor BUS communication signal
receiving status
Upon receiving signal: [... ... 1], Other times: [... ... ...]
B5 Indoor check code No check code: [– – –]
B
6
Indoor HP capacity 0. 2, 0. 5, 0. 8, ... 1, 1. 2, 1. 7, ... 2, 2. 5,
...3, 3. 2, ...4, ...5, ...6, ...8, 1 0, 1 6, 2 0
8 Indoor PMV opening data Displayed in decimal format
9
1~4
1~16
Indoor TA / TRA opening data Displayed in decimal format
11~1 Indoor TSA opening data
Displayed in decimal format
10 Displayed in decimal format
1~ Indoor TF / TFA opening data
11~1
Indoor TOA opening data
Displayed in decimal format
B11 Indoor TCJ opening data Displayed in decimal format
B12 Displayed in decimal format
B13
1~ Indoor TC1 opening data
Indoor TC2 opening data
Displayed in decimal format
B
7
Indoor request command
(S code, operation mode)
[ #. ... ]
# represents mode:
COOL: [C. ...
], HEAT: [H. ... ]
FAN: [F. ... ], OFF: [S. ... ]
represents S code: [#. ... 0] to [#. ... F]
SW01 SW02 SW03 Display detail
Note: Indoor address No. is selected by setting SW02 and SW03 and displayed on 7-segment display, section A.
B
B
B
B
B
SW02
1~16
SW03
1
11
2
12
3
13
Indoor address
SW02 setting number
SW02 setting number +16
SW02 setting number +32
7-segment display section A
[01]~[16]
[17]~[32]
[33]~[48]
4
14
SW02 setting number +48
[49]~[64]