STE 80897
– 1–5 –
TRANSPORTATION & INSTALLATION MANUAL
1.3 Storage
Both the robot and controller should not be stored for a long period of time after
unpacked. When this is unavoidable, however, be sure to observe the following
cautions on storage.
1.3.1 Cautions on Robot Storage
!
CAUTION
• Secure the robot base completely to prevent the robot from falling over.
• Keep the robot out of direct sunlight. Otherwise, the parts may deteriorate.
• Seal the robot in a vinyl bag to prevent rust development and contaminant.
Put a desiccant in the bag to absorb moisture.
• When the robot motor drive cable was disconnected from the controller,
connect the short-circuit connector to the same cable.
1.3.2 Cautions on Robot Controller Storage
!
CAUTION
• Keep the robot controller out of direct sunlight. Otherwise, the controller
interior will be heated up, resulting in faults.