STE 80897
– 2–1 –
TRANSPORTATION & INSTALLATION MANUAL
Section 2 Installation
2.1 Installation Environment
Table 2.1 shows the environmental conditions for the location in which the robot and
controller TS2000 are to be installed.
Table 2.1 Environmental conditions for the robot and controller
Item Specifications
Temperature At operation : 0 ~ 40°C
At storage : –10°C ~ 50°C
Humidity 20 ~ 90 % (non-condensing)
DO NOT install the robot and controller at places where
they are exposed to splash of liquids such as water.
Altitude 1,000 m or less
Vibration
At operation : 0.98 m/s
2
or less
At transport : 9.8 m/s
2
or less
Dust No inductive dust should be involved.
Consult with Toshiba Machine first if you have to use the
robot and controller in a hostile environment.
Gas No corrosive gas or combustible gas should be involved.
Sunlight The robot and controller should not be exposed to direct
sunlight.
Power source noise No device causing an excessive noise should exist nearby.
Magnetic field No device causing a strong magnetic field should exist
nearby.
!
DANGER
• DO NOT place the robot and controller near combustibles. Otherwise, fires
could be caused if the material ignites due to a fault, etc.
To Next Page
Loading...
