Toshiba TVL Series - Page 122

TRANSPORTATION AND INSTALLATION MANUAL
122
a-2) Input signal connector HAND (TSL3100 Type-P)
Pin
Signal name
Signal No.
Input circuit and example of connections
A1
D_IN1
Input signal 1
201
The INPUTCOM signal is the same as that of the
pins 6, 17 and 30 connected to the INPUT
connector on the controller front face.
B1
D_IN2
Input signal 2
202
A2
D_IN3
Input signal 3
203
B2
D_IN4
Input signal 4
204
A3
D_IN5
Input signal 5
205
B3
D_IN6
Input signal 6
206
A4
D_IN7
Input signal 7
207
B4
D_IN8
Input signal 8
208
A5
DC 24V(P24V)
As input signals, no-voltage contacts or transistor open collector inputs are used.
No-voltage contact specifications:
Contact rating: 24 VDC, 10 mA or over (circuit current: approx. 7 mA)
Minimum contact current: 24 VDC, 1 mA
Contact impedance: 100  or less
Transistor specifications:
Withhold voltage between collector and emitter: 30 V or over
Current between collector and emitter: 10 mA or over (circuit current: approx. 7 mA)
Leak current between collector and emitter: 100 µA or less
●
●
P24G
Contact or
transistor
Customer’s side
TSL3100
[Sink type (-Common)]
INPUTCOM