TRANSPORTATION AND INSTALLATION MANUAL
5
• Always read through the Safety Manual provided separately before starting
actual work to ensure safety work covering from the robot installation to
operation.
[Installation and transportation]
Always observe the following items to safely use the robot.
• DO NOT install or operate if any parts are damaged or missing.
Doing so could lead to electric shocks, fires or faults.
• DO NOT install the robot where it may be subject to fluids such
as water. Doing so could lead to electric shocks, fires or
faults.
• Do not place the robot near combustible matters. Doing so
could lead to fires if the matter ignites due to a fault, etc.
• Always secure the robot with the attached clamps before
transporting it. Failure to do so could lead to injuries if the arm
moves when the robot is suspended.
• Wire the robot after installation.
Wiring the robot before installation could lead to electric shocks
or injuries.
• Always use the power voltage and power capacity designated
by Toshiba Machine. Failure to do so could lead to device
faults or fires.
• Always use the designated power cable. Using a cable other
than that designated could lead to fires or faults.
• Completely connect the grounding cable. Failure to do so
could lead to electric shocks or fires if a fault or fault current
occurs. Noise could lead to malfunction.
Also, it could cause mis-operation by noise.
To Next Page
Loading...
