tousek / E_PULL-T5-T8-T10_49002305 / 19. 12. 2013 - 25 -
Important notes after installation
• Installation, connection, adjustments, putting into operation, and servicing may only be carried out by trained
professionals in full accordance with these installation- and operating instructions.
• The packaging materials (cardboard, plastic, EPS foam parts and lling material etc.) have to be properly disposed of
in accordance with the applying recycling and environmental protection laws. They may be hazardous to children and
therefore have to be stored out of children´s reach.
• The product is not suitable for installation in explosion-hazardous areas.
• The product may only be used in accordance with its original purpose, for which it has been exclusively designed, and
which is described in these installation and operating instructions (especially children have to be instructed). The TOUSEK
Ges.m.b.H. rejects any liability if the product is used in any way not fully conforming to its original purpose as stated
herein.
• All electrical installations have to be made in full conformity with the applying rules and laws (e.g. using a fault
current circuit breaker, proper grounding etc.).
• An all-pole disconnecting main switch with a contact opening-gap of minimum 3 mm has to be foreseen.
• The electric motor heats up during operation. Therefore the device should only be touched after it has cooled off.
• After installation the proper function of the gate facility and the safety devices has to be checked!
• The installer has to inform the user about all aspects of the automatic operation of the complete gate facility, as well as
about emergency operation. The installer further has to supply to the user all instructions relating to the safe operation
of the gate facility. The installation and operating instructions also have to be handed over to the user..
To Next Page
Loading...
