TP-Link JetStream T1600G-28TS - Page 170

161
Figure 10-10 Rate Limit
The following entries are displayed on this screen:
 Rate Limit Config
UNIT:1/LAGS: Click 1 to configure the physical ports. Click LAGS
to configure
the link aggregation groups.
Select: Sel
ect the desired port for Rate configuration. It is
multi-optional.
Port: Displays the port number of the switch.
Ingress Rate
(1-1000000Kbps):
Configure the bandwidth for receiving packets on the port. You
can select a rate from the dropdown list or manu
ally set Ingress
rate, the system will automatically select integral multiple of
64Kbps that closest to the rate you entered as the real Ingress
rate.
Egress
Rate(1-
1000000Kbps):
Configure the bandwidth for sending packets on the port. You can
select a ra
te from the dropdown list or manually set Egress rate,
the system will automatically select integral multiple of 64Kbps
that closest to the rate you entered as the real Egress rate.
LAG: Displays the LAG number which the port belongs to.
Note:
1. If you enable ingress rate limit feature for the storm control-enabled port, storm control feature
will be disabled for this port.
2. When manually set Ingress/Egress rate, the system will automatically select integral multiple
of 64Kbps that closest to the rate you entered as the real Ingress/Egress rate. For example, if
you enter 1000Kbps for egress rate, the system will automatically select 1024Kbps as the real
Egress rate.