TP-Link JetStream T1600G-28TS - History

229
14.3.2 History
On this page, you can configure the History Group for RMON.
Choose the menu SNM P→RMON→History to load the following page.
Figure 13-10 History Control
The following entries are displayed on this screen:

History Control Table
Select:
Select the desired entry for configuration.
Index:
Displays the index number of the entry.
Port:
Specify the port from which the history samples were taken.
Interval:
Specify the interval to take samplings from the port.
Max Buckets:
Displays the maximum number of buckets desired for the RMON
history group of statistics, ranging from 1 to 130
. The default is 50
buckets. 130 buckets supported at most so far.
Owner:
Enter the name of the device or user that defined the entry.
Status:
Select Enable/Disable the corresponding sampling entry.