30
4.3.1 Boot Config
On this page you can configure the boot file of the switch. When the switch is powered on, it will
start up with the startup image. If it fails, it will try to start up with the backup image. If this fails too,
you will enter into the bootutil menu of the switch.
Choose the menu Syste m → System Tools → Boot Config to load the following page.
Figure 4-12 Boot Config
The following entries are displayed on this screen:
Boot Table
Select: Select the unit(s).
Unit: Displays the unit ID.
Current Startup
Image :
Displays the current startup image.
Next Startup Image: Select the next startup image.
To Next Page
Loading...
