TP-Link JetStream T1600G-28TS - Protocol Template

81
Figure 6-10 Enable Protocol VLAN for Port

Protocol Group Config
Protocol Name:
Select the defined protocol template.
VLAN ID:
Enter the ID number of the
Protocol VLAN. This VLAN should be one
of the 802.1Q VLANs the ingress port belongs to.

Protocol Group Member
UNIT:
1/LAGS Click 1 to configure the physical ports. Click LAGS
to configure the
link aggregation groups.
6.5.3 Protocol Template
The Protocol Template should be created before configuring the Protocol VLAN. By default, the
switch has defined the IP Template, ARP Template, RARP Template, etc. You can add more
Protocol Template on this page.
Choose the menu VLAN→Protocol VLAN→Protocol Template to load the following page.